1. |
Remove the front door trim panel.
(Refer to Body - "Front door")
|
2. |
Disconnect the switch connector (A) from wiring.
|
3. |
Check the switch for continuity between the No. 1 and No. 2 terminals.
If the continuity is not as specified, replace the switch.
|
Oil Cooler Installation
1.
Apply a light coat of engine oil to the oil cooler packing surface (A),
and then install the oil cooler with fix bolt (B).
Tightening torque:
...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Direct Electro Hydraulic Actuator Coupling Inspection
All units are filled up with coupling fluid (ultra-low viscosity
ATF) prior to shipping. Inspection, fill-up, and replac ...