1. |
BSD system defects can be quickly diagnosed with the GDS. GDS
operates actuator quickly to monitor, input/output value and self diagnosis.
|
2. |
Connect the cable of GDS to the data link connector in driver
side crash pad lower panel, turn the power on GDS.
|
3. |
Select the vehicle model and then BSD system.
|
4. |
Select "Input/output monitoring", if you want to check current
data of BSD system.
|
5. |
If you want to check each module operation forcefully, select
"Actuation test".
|
Front Body E
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Hood hinge m ...
Rear Driveshaft Removal and Installation
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
BJ Boot Removal and Installation
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...