1. |
Disconnect the negative (-) battery terminal.
|
2. |
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defrost nozzle after disconnecting the connector (B).
|
3. |
Install in the reverse order of removal.
|
IMS Power Seat Control Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Vehicle load limit
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number
of people tha ...
Parking Brake Lever Assembly Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
...