Kia Sorento: If the engine will not start - Emergency while driving - What to do in an emergency - Kia Sorento XM Owners ManualKia Sorento: If the engine will not start

Second Generation XM (2011-2024) / Kia Sorento XM Owners Manual / What to do in an emergency / Emergency while driving / If the engine will not start

If engine doesn't turn over or turns over slowly

1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2.Check the battery connections to be sure they are clean and tight.

3.Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4.Check the starter connections to be sure they are securely tightened.

5.Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING

If the engine will not start, do not push or pull the vehicle to start it. This could result in a collision or cause other damage. In addition, push or pull starting may cause the catalytic converter to overload and create a fire hazard.

If engine turns over normally but does not start

1.Check the fuel level.

2.With the ignition switch in the LOCK position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose.

3.Check the fuel line in the engine compartment.

4.If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.

Emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you ha ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle ...

See also:

Front Fog Lamps Installation
1. Install the front fog lamp bulb. 2. Connect the fog lamp connector. 3. Install the front tire wheel guard. ...

Piston and Connecting Rod Reassembly
   • Thoroughly clean all parts to be assembled. • ...

Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the tire. Replace the tire when t ...

Copyright © www.ksmanual.com 2014-2024