1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pullty")
|
2. |
Remove the front oil seal(A).
|
3. |
Install the crankshaft front oil seal (A) using SST (09214-2W100, 09231-H1100)
(B).
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...