1. |
Install the spring lower pad (D) so that the protrusions(A) fit
in the holes (C) in the spring lower seat (B).
|
2. |
Compress coil spring using special tool (09546-26000). Install
compressed coil spring into shock absorber.
|
3. |
After fully extending the piston rod, install the spring upper
seat and insulator assembly.
|
4. |
After seating the upper and lower ends of the coil spring (A)
in the upper and lower spring seat grooves (B) correctly, tighten new
self-locking nut temporarily.
|
5. |
Remove the special tool (09546-26000).
|
6. |
Tighten the self-locking nut to the specified torque.
|
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Inhibitor Switch
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
...
Oil Pressure Switch Inspection
1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
2.
...