1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
Remove the emergency fastening device cover pad (A). [Driver only]
|
3. |
Remove the seat belt after pushing the lock pin with a fiat-tip
screwdriver (B).
|
4. |
Remove the door scuff trim. (Refer to the Body group- Interior
trim)
|
5. |
Remove the center pillar trim. (Refer to the Body group- Interior
trim)
|
6. |
Remove the seat belt upper mounting bolt.
|
7. |
Loosen the seat belt pretensioner mounting bolt (A, B) and remove
the seat belt pretensioner.
|
8. |
Disconnect the seat belt pretensioner connector.
|
CVVT & Camshaft Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve
timing of the intake and exhaust valve in accordance with the ECM control signal
which is calculated by the engine ...
Hands Free Switch Installation
1.
Install the handsfree remote switch to the steering wheel front
cover.
2.
Install the steering wheel front cover.
3 ...
Rear Differential Carrier Reassembly
Pinion drive gear height adjustment
Adjust the height of the drive pinion in the following order.
1.
Below are the special tools to measure the pinion height
...