1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
|
3. |
Install the EFD with a bolt (B).
|
4. |
Connect the EFD connector (A).
|
5. |
Install the center pillar trim. (Refer to the Body group- Interior
trim)
|
6. |
Install the door scuff trim. (Refer to the Body group- Interior
trim)
|
7. |
Insert the seat belt to the anchor pretensioner.
|
8. |
Attaches EFD cover pad (A) on EFD.
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the EFD, confirm proper system operation:
|
Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump
and controls fuel flow flowing into the injectors in accordance with the ECM
signal calculated based on various engine ...
ESC OFF Switch Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer the Body - & ...
Intake Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuato ...