Kia Sorento: Rear Body
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Side outer panel rear corner |
Tail gate hinge mounting hole (Ø12) |
Tail gate lifter mounting hole (Ø11) |
|
|
|
|
| Rear combination lamp mounting hole (Ø8) |
Rear bumper mounting hole (Ø9) |
Rear bumper mounting hole (20X18) |
|
|
||
| Rear bumper mounting hole (20X18) |
Interior D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front pillar ...
Under Body (2WD)
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Actual-Measurement Dimensions
...
See also:
Body Panel Gaps
...
Rear Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Copyright В© www.ksmanual.com 2014-2024