|
1. |
Remove the following parts.
|
2. |
Loosen the front mud guard mounting clips and screws.
|
3. |
After loosening the mounting clips, then remove the fender side
cover (A).
|
4. |
After loosening the mounting bolts, then remove the fender assembly
(A).
|
5. |
Install in the reverse order of removal.
|
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Circuit Diagram
Connector Pin Information
No.
Wire harness connector
Panorama motor
Blind motor
1
Ground 1 ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...