Kia Sorento: Specification
| Item |
Specification |
| Coil Resistance (Ω) |
1.18 ~ 1.31 [20°C(68°F)] |
Injector
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling as it exits th ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
See also:
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Spark Plug Installation
1.
Install in the reverse order of removal.
Tightening torque:
14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.8 ~ 18.0 Ib-ft)
...
Oil hydraulic Motor(Actuator) Installation
1.
Before installation, wipe the surface with a clean cloth.
2.
Check the O-rings (A) of the new hydraulic motor (actuators).
...
Copyright © www.ksmanual.com 2014-2024