1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
2. |
Select the vehicle model and then do "Smart key code saving".
|
3. |
After selecting "Smart key teaching" menu, push "Enter" key, then
the screen will be shown as below.
|
4. |
After having the teaching smart key, push "ENTER" key.
|
5. |
Input the "Pin code" for first key teaching.
|
6. |
Press the SSB with smart key within 5 sec after pressing "OK".
|
7. |
Confirm the message "First key teaching completed".
|
8. |
Press the SSB with smart key within 5 sec after pressing "OK".
|
9. |
Confirm the message "Second key teaching completed".
|
10. |
Then the screen will be shown as below when key teaching process
is completed.
|
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...
Description
System Operation
Typically, lane departure warning is activated at a speed over 60 km,
but suppressed in case of unintentional lane departure when driver do not operate
turn signal.
S ...
Ignition Coil Specification
Item
Specification
Primary Coil Resistance (Ω)
0.62 ± 10% [20°C (68°F)]
Secondary Coil Resistance (kΩ)
7.0 ± 15% [20 ...