Kia Sorento: Transmitter Code Registration (Using GDS) - Keyless Entry And Burglar Alarm - Body Electrical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Transmitter Code Registration (Using GDS)

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Transmitter Code Registration (Using GDS)

1.
Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.

2.
Select the vehicle model and then do "CODE SAVING"

3.
After selecting "CODE SAVING" menu, button "ENTER" key, then the screen will be shown as below.

4.
After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps 1 to 4 and then code saving is completed.

Transmitter Inspection
1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check ...

BCM (Body Control Module)
...

See also:

Filter replacement
It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Loosen the air clean ...

Heater Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. ...

Front Lower Arm Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Copyright В© www.ksmanual.com 2014-2025