Kia Sorento: Rear Glass Defogger Printed Heater Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Rear Glass Defogger / Rear Glass Defogger Printed Heater Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on the tin foil, moving
the tin foil along the grid line to check for open circuits.
|
| 1. |
Turn on the defogger switch and use a voltmeter to measure the
voltage of each heater line at the glass center point. If a voltage
of approximately 6V is indicated by the voltmeter, the heater line of
the rear window is considered satisfactory.
|
| 2. |
If a heater line is burned out between the center point and (+)
terminal, the voltmeter will indicate 12V.
|
| 3. |
If a heater line is burned out between the center point and (-)
terminal, the voltmeter will indicate 0V.
|
| 4. |
To check for open circuits, slowly move the test lead in the direction
that the open circuit seems to exist. Try to find a point where a voltage
is generated or changes to 0V. The point where the voltage has changed
is the open-circuit point.
|
| 5. |
Use an ohmmeter to measure the resistance of each heater line
between a terminal and the center of a grid line, and between the same
terminal and the center of one adjacent heater line. The section with
a broken heater line will have a resistance twice as that in other sections.
In the affected section, move the test lead to a position where the
resistance sharply changes.
|
Repair Of Broken Heater Line
Prepare the following items :
| 1. |
Conductive paint.
|
| 2. |
Paint thinner.
|
| 3. |
Masking tape.
|
| 4. |
Silicone remover.
|
| 5. |
Using a thin brush :
Wipe the glass adjacent to the broken heater line, clean with
silicone remover and attach the masking tape as shown. Shake the conductive
paint container well, and apply three coats with a brush at intervals
of about 15 minutes apart. Remove the tape and allow sufficient time
for drying before applying power. For a better finish, scrape away excess
deposits with a knife after the paint has completely dried. (Allow 24
hours).
|
Component Location
1. Rear glass defogger relay
2. Rear glass defogger switch
3. Rear glass defogger
...
Rear Glass Defogger Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...
See also:
Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System
and lap/shoulder belts at both the driver and passenger seating position.
The indication of the system's prese ...
Drive Belt Inspection
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
...
Speakers Installation
Front speaker
1.
Install the speaker to the speaker mounting hole in the door in-panel.
2.
Reconnect the speaker connector.
Rea ...
Copyright В© www.ksmanual.com 2014-2024