Kia Sorento: Rear Wiper Motor Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Installation
| 1. |
Install the rear wiper motor assembly.
|
| 2. |
Install the tailgate trim.
|
| 3. |
Install the rear wiper arm and rear wiper cap.
|
| 4. |
Install the rear wiper arm and blade to align with black rear
defogger line (A).
|
| 5. |
Set the rear washer nozzle on the specified spray position.
|
Rear Wiper Motor Removal
1.
Detach the rear wiper cap (A).
2.
Remove the rear wiper arm & blade (A) after removing rear wiper
HEX nut (B).
...
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...
See also:
Battery Vehicle parasitic current inspection
1.
Turn the all electric devices OFF, and then turn the ignition
switch OFF.
2.
Close all doors except the engine hood, and then lock all d ...
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the volt ...
Rear combination lamp Removal
1.
Disconnect the negative (-) battery terminal.
[Outside]
2.
Loose the screws (2EA) holding the rear combination lamp then
disconn ...
Copyright © www.ksmanual.com 2014-2024