Kia Sorento: Circuit Diagram
Connector Pin Information
| No. |
Wire harness connector |
Panorama motor |
Blind motor |
|
|
|
|
|
| 1 |
Ground 1 |
Ground 1 |
Ground 2 |
| 2 |
Glass status signal / Tool fot glass |
Glass status signal/ Tool (Parameter) |
Tool (Parameter) |
| 3 |
IGN 2 |
IGN 2 |
- |
| 4 |
Tilu up switch |
Tilu up switch |
- |
| 5 |
- |
- |
- |
| 6 |
Battery 1 |
Battery 1 |
Battery 2 |
| 7 |
Ground 2 |
Serial |
Serial |
| 8 |
Vehicle speed signal |
Vehicle speed signal |
Vehicle speed signal |
| 9 |
Glass open switch |
Glass open switch |
Blind open switch |
| 10 |
Glass close switch |
Glass close switch |
Blind close switch |
| 11 |
Blind open switch |
|
|
| 12 |
Serial |
||
| 13 |
Blind close switch |
||
| 14 |
Battery 2 |
||
| 15 |
Blind tool |
||
| 16 |
- |
Component Location
1. Panorama sunroof (Panorama)
2. Panorama sunroof switch
3. Panorama sunroof motor & controller (Master)
4. Roller blind motor & controller (Slave)
...
See also:
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals
of multi-function switch connector.
...
IMS Power Seat Control Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Copyright В© www.ksmanual.com 2014-2024