1. |
Disconnect the negative (-) battery terminal.
|
2. |
Open the sunglass case cover from the overhead console then remove
the 2 screws holding the overhead console. Disconnect the switch connector
(6P) and Map lamp connector (6P), and then remove the overhead console
lamp (A).
|
3. |
Check for continuity between the terminals. If the continuity
is not as specified, replace the sunroof switch.
|
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD (Emergency Fastening Device)).
The pre-tensioner seat belts may be act ...
4WD ECU Circuit Diagram and Connector
4WD ECU Connector
Pin
Function
1
MOTOR A
2
MOTOR B
3
LOCK MODE SWITCH (Input)
4
-
...
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.62 ± 10% [20°C (68°F)]
Secondary Coil Re ...