1. |
Turn the ignition key to the ON position and then close the panoramaroof
completely.
|
2. |
Release the panoramaroof control lever.
|
3. |
Press and hold the CLOSE button for more than 10 seconds until
the sunroof has moved slightly.
|
4. |
Release the panoramaroof control lever.
|
5. |
Press and hold the CLOSE button once again within 5 seconds until
the panorama sunroof do as follows ;
|
6. |
Reset procedure of panorama system is finished.
|
1. |
The panoramaroof ECU detects the Run- time of motor
|
2. |
Motor can be operated continuously for the 1st Run-time(120 ±
10sec.).
|
3. |
Motor which is operated continuously stops operating after the
1st Run-time(120 ± 10sec.).
|
4. |
And then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
|
5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued
motor operation after 1st Cool-time(18 ± 2sec.)
|
6. |
Motor which is operated continuously stops operating after the
2nd Run-time(10 ± 2sec.)
|
7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
|
8. |
Motor repeats the 2nd Run-time and 2nd Cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
Windshield Wiper-Washer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after loosening
3 screws.
...
Climate control air filter (if equipped)
The climate control air filter installed behind the glove box filters the dust
or other pollutants that come into the vehicle from the outside through the heating
and air conditioning system.
If ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's side crash
pad side cover.
...