1. |
Install the immobilizer control unit after connecting the unit
connector.
|
2. |
Install the crash pad lower panel.
|
Power Mosfet (DATC) Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower
resistor must be rep ...
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Description
Limitations Of The Navigation system
GPS Signal Reception State
As the GPS satellite frequency is received/transmitted in straight lines,
reception may not work if hiding devices are pla ...