Kia Sorento: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to Steering System - "Steering column")
|
| 3. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad")
|
| 4. |
Remove the ignition switch (A) after disconnecting the 6P connector
(A).
|
| 5. |
Remove the key warning and immobilizer connector (A).
|
| 6. |
Remove the key illumination lens (A).
|
| 7. |
Remove the key illumination bulb and cover (A).
|
| 8. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder with key ACC.
|
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
2.
Che ...
Installation
1.
Install the key lock cylinder.
2.
Install the illumination bulb, lens and cover.
3.
Install the key warning ...
See also:
If the engine will not start
If engine doesn't turn over or turns over slowly
1.If your vehicle has an automatic transaxle, be sure the shift lever is in N
(Neutral) or P (Park) and the emergency brake is set.
2.Check the ...
Power Door Mirror Switch Installation
Driver Door Mirror Switch
1.
Install the driver door module and connectors.
2.
Install the front door trim.
...
Head Lamps Component (1)
1. Head lamp assembly
2. Head lamp high beam bulb
3. Head lamp low beam bulb
4. Dust cap
5. Turn signal lamp socket & bulb
...
Copyright В© www.ksmanual.com 2014-2024