Kia Sorento: Removal
| 1. |
Remove the tailgate trim in the trunk after removing the screws
and clips.
(Refer to Body - "Tailgate")
|
| 2. |
Remove the tailgate garnish (A) after disconnecting the connector.
|
| 3. |
Remove the back view camera (A) after removing the screws (2EA).
|
Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehic ...
Installation
1.
Install the back view camera.
2.
Install the tailgate garnish and trim.
...
See also:
Cruise Control Switch Removal
1.
Disconnect the battery (-) terminal.
2.
Remove the air-bag module from the steering wheel. ( Refer to
RT group)
3.
...
Warning Messages
Shift to "P" position (for smart key system and automatic transaxle)
This warning message illuminates if you try to turn off the engine without
the shift lever in P (Park) position.
...
Description
BSD is a system that uses two magnetic wave radar sensors attached on
the rear bumper to measure the distance from the following vehicles and provides
the sensing and (visual and auditory) al ...
Copyright В© www.ksmanual.com 2014-2025