Item |
Specification |
||
Compressor |
Type |
DVE18 (External Variable Displacement Swash Plate) |
|
Oil type & Capacity |
Front only |
PAG 120± 10cc (4.1±0.3oz.) |
|
Front & Rear |
PAG 180 ± 10cc (6.1±0.3oz.) |
||
Pulley type |
6PK-TYPE |
||
Displacement |
180cc/rev |
||
Condenser |
Heat rejection |
DSL : 14,600-5% kcal/hr (16.1-5% kw) GSL : 16,000-5% kcal/hr (18.8-5% kw) |
|
Expansion valve |
Type |
Block type |
|
Refrigerant |
Type |
HFC-134a |
|
Capacity |
Front only |
600 ± 25g (21.1 ± 0.88oz.) |
|
Front & Rear |
750 ± 25g (26.4 ± 0.88oz.) |
Item |
Specification |
|
Fresh and recirculation |
Operating method |
Actuator |
Blower |
Type |
Sirocco |
Speed step |
Auto + 8 speed (Automatic), 1~4speed (Manual) |
|
Speed control |
Power mosfet (Automatic), Resistor (Manual) |
|
Air filter |
Type |
Particle filter |
Item |
Specification |
|
Heater |
Type |
Pin & Tube type |
Heating capacity |
4,700 - 5% kcal/hr |
|
Mode operating method |
Actuator |
|
Temperature operating method |
Actuator |
|
Evaporator |
Temperature control type |
Evaporator temperature sensor |
A/C ON/OFF |
ON: 3.0±0.3°C (37.4±0.5°F) OFF: 1.0±0.3°C (33.8±0.5°F) |
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Components Location
Supplemental Restraint System Control
Module (SRSCM)
Driver Airbag (DAB) / Passenger Airbag
(PAB)
Side Airbag (SAB)
Curtain Airbag (CA ...
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...