Kia Sorento: Rear Blower Unit Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Unit Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Recover the refrigerant with a recover/recycling/charging station.
|
| 3. |
When the engine is cool, drain the engine coolant from the radiator.
|
| 4. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
| 5. |
Remove the blower motor (B) after disconnecting the blower motor
connector (A) and loosening the mounting screws.
|
| 6. |
Install in the reverse order of removal.
|
Rear Air Conditioner Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Wheel Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Reservoir Tank Removal and Installation
1.
Remove the over flow hose(A).
2.
Remove the reservoir tank(B) after loosening the bolts.
Tightening torque:
...
Copyright В© www.ksmanual.com 2014-2024