Kia Sorento: Radiator Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cooling System / Radiator Inspection
Radiator Cap Testing
| 1. |
Remove the radiator cap, wet its seal with engine coolant, and then
install it on a pressure tester.
|
| 2. |
Apply a pressure of 79.4 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 11.5 ~ 17.78
psi).
|
| 3. |
Check for a drop in pressure.
|
| 4. |
If the pressure drops, replace the cap.
|
Radiator Leakage Test
| 1. |
Wait until engine is cool, then carefully remove the radiator cap and
fill the radiator with engine coolant, then install it on the pressure
tester.
|
| 2. |
Apply a pressure tester to the radiator and apply a pressure of 93.16
~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 13.51 ~ 17.78 psi).
|
| 3. |
Inspect for engine coolant leaks and a drop in pressure.
|
| 4. |
Remove the tester and reinstall the radiator cap.
|
Radiator Removal and Installation
1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner" ...
Cooling Fan Components
1. Upper air guard
2. Cooling fan control module
3. Cooling fan shroud
4. Fan motor
5. Cooling fan
...
See also:
IPM Components
Outer Connector (L / M / N / K)
Connector
Pin No.
Description
Active
Remark
K
1
IMS LIN
...
Front Fog Lamps Inspection
1.
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunctio ...
Component Location
1. Hood switch
2. Burglar horn
3. IPM & RF receiver
4. Key warning switch
5. Front door switch
6. Front door lock actuator & switch
7. Rear door lock actuator ...
Copyright В© www.ksmanual.com 2014-2024