Kia Sorento: Water Temperature Control Assembly Components
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Components
| 1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor |
5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant hose |
Reservoir Tank Removal and Installation
1.
Remove the over flow hose(A).
2.
Remove the reservoir tank(B) after loosening the bolts.
Tightening torque:
...
Water Temperature Control Assembly Removal
1.
Disconnect the battery negative terminal.
2.
Loosen the drain plug and drain the engine coolant.
3.
Remove ...
See also:
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition ...
Parking Brake Assembly Installation
Parking Brake Shoe
1.
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
2.
Install the ope ...
Windshield Glass Installtion
1.
With a knife, scrape the old adhesive smooth to a thickness of
about 2mm (0.08 in.) on the bonding surface around the entire windshield
opening flange :
...
Copyright В© www.ksmanual.com 2014-2024