Kia Sorento: Canister Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation tube quick-connector (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Disconnect the vapor tube quick-connector (A).
|
| 6. |
Remove the canister assembly bracket (D) after removing the mounting
bolts (B) and nut (C).
|
| 7. |
Remove the canister braket (B) installation bolt (A).
|
| 8. |
Remove the fuel tank air filter & canister close valve assembly
(A) after rotating it in the direction of the arrow in the figure.
|
Inspection
[Evap Leak Test]
Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV)
and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are
satisfied ...
Canister Inspection
1.
Check for the following items visually.
A.
Cracks or leakage of the canister
B.
Loose connectio ...
See also:
Engine Mounting Components
1. Transaxle mounting bracket
2. Roll rod bracket
3. Engine mounting bracket
4. Engine mounting support bracket
...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts with the specified tightening
order.
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Copyright В© www.ksmanual.com 2014-2024