Kia Sorento: Inspection

Circuit Diagram

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A). ...

See also:

Oil Seal Replacement
[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Re ...

Rear Driveshaft Components
1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot ...

Fuel requirements
Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance w ...