Kia Sorento: Delivery Pipe Installation
| •
|
Install the component with the specified torques.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not use already used injector O-ring again.
|
|
| •
|
Do not reuse the bolts.
|
|
| •
|
When insert the injector, be careful not to damage the
injector tip.
|
|
| •
|
Use proper tooling for change of combustion seal. Take
proper precautions not to damage surface during assembly or
disassembly.
|
|
| •
|
Avoid dropping the fuel pipe (including injectors) or
bumping it into any hard objects sincedamage to the internal
components may occur. If necessary, visually inspect and confirmproper
operation with performance tests prior to reuse.
|
| •
|
Before installing the injector into the cylinder head,
clean the injector hole and avoidcontaminants from entering
inside the injector hole. When installing the injector, avoid
bumpingthe injector tip into any of the surrounding components
since the tip may become damagedfrom the impact.
|
| •
|
When fastening the three fuel delivery pipemounting bolts,
fully hand-tighten first, andthen tighten in the proper sequence
( →  →
 ) in several cycles up tothe specified
torque. The delivery pipeshould move less than 1/8 inch (approx.3mm),
whenever each bolt is tightened.
|
|
|
1. |
Install in the reverse order of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
High pressure fuel pipe installation
nut:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)
|
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
See also:
Climate Control Air Filter Description
The climate control air filter is located in the blower unit. It eliminates
foreign materials and odor. The particle filter performs a role as an odor filter
as well as a conventional dust fi ...
Positive Crankcase Ventilation (PCV) Valve Inspection
1.
Insert a thin stick (A) into the PCV valve (B) from the threaded
side to check that the plunger moves.
...
Head Lamps Component (2)
1. Head lamp assembly
2. Head lamp high beam bulb
3. Head lamp low beam bulb (HID & ignitor)
4. Dust cap
5. Turn signal lamp socket & bulb
...
Delivery Pipe Removal
High Pressure Fuel Pump Removal