If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console (1).
The sunroof can only be opened, closed, or tilted when the ignition switch is in the ON position.
✽ NOTICE
CAUTION
Do not continue to pull or push the sunroof control lever after the sunroof is fully opened, closed, or tilted. Damage to the motor or system components could occur.
✽ NOTICE
The sunroof cannot tilt when it is in the slide position but can be slid while in a tilt position.
WARNING
Sunroof open warning (if equipped)
If the driver removes the ignition key (smart key: turns off the engine) and opens the driver-side door when the sunroof is not fully closed, the warning chime will sound for a few seconds and a message "Sunroof Open" will appear on the LCD display.
Close the sunroof securely when leaving your vehicle.
Sliding the sunroof
When the sunshade is closed
If you pull the sunroof control lever backward, the sunshade and sunroof glass will slide all the way open. To stop the sunroof movement at any point, pull or push the sunroof control lever momentarily.
When the sunshade is opened
If you pull the sunroof control lever backward, the sunroof glass will slide all the way open. To stop the sunroof movement at any point, pull or push the sunroof control lever momentarily.
❈ The front part of the sunroof glass can only be opened and closed.
Automatic reversal
If an object or part of the body is detected while the sunroof is closing automatically, it will reverse the direction, and then stop.
The auto reverse function does not work if a tiny obstacle is between the sliding glass and the sunroof sash.
You should always check that all passengers and objects are away from the sunroof before closing it.
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...
Air Cleaner Removal and Installation
1.
Remove the engine cover.
2.
Remove the air duct (A).
3.
Remove the battery.
(Refer to Engi ...