Kia Sorento: Rear Shock Absorber Installation - Rear Suspension System - Suspension System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Rear Shock Absorber Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Installation

1.
Installation is the reverse of removal.
  
After checking the distance 454±10mm (17.8740±0.3937 in.) between the wheel housing garnish (A) and the hub assembly (B) as shown in the illustration, tighten the mounting bolts and nuts of rear chassis part with specified torque.

Rear Shock Absorber Inspection
1. Check the rubber parts for damage or deterioration. 2. Check the shock absorber for abnormal resistance or unusual sounds. ...

Rear Upper Arm Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

See also:

Illuminated ignition switch (if equipped)
Whenever a front door is opened, the ignition switch will illuminate for your convenience, provided the ignition switch is not in the ON position. The light will go off immediately when the igniti ...

Master Cylinder Removal
1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. G 2.4 GDI (Refer to ...

Description
EPS (Electric power steering, Column assist type) system uses an electric motor to assist the steering force and it is an engine operation independent steering system. EPS control module ...

Copyright © www.ksmanual.com 2014-2025