1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Support the rear lower arm (A) with a jack as shown in the illustration.
|
3. |
Loosen the bolt & nut and then remove the rear upper arm (A).
[2WD]
[4WD]
|
4. |
Installation is the reverse of removal.
|
TPMS Receiver Operation
1.
General Function
A.
Auto learn takes place only once per Ignition cycle.
B.
On successful compl ...
Brake Booster Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Speakers Inspection
1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the
s ...