Kia Optima Manuals

Kia Sorento: Trailing Arm Replacement - Rear Suspension System - Suspension System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Trailing Arm Replacement

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Suspension System / Rear Suspension System / Trailing Arm Replacement

1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

  
Be careful not to damage to the hub bolts when removing the front wheel & tire (A).
2.
Loosen the nuts & bolts and then remove the trailing arm (A) with the rear axle.
Tightening torque
Bolt: 34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)
Nut: 6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0lb-ft)
[2WD]

[4WD]
3.
Loosen the parking brake cable bracket bolt (A) & height sensor bracket bolt (B).
Tightening torque
A: 9.8 ~ 16.7N.m (1.0 ~ 1.7kgf.m, 7.2 ~ 12.3lb-ft)
B: 3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
[2WD]

[4WD]
4.
Loosen the mounting bolt and then remove the trailing arm (A) with the frame.
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

5.
Installation is the reverse of removal.
Rear Coil Spring Inspection
1. Check the spring for distortion, aging or damage. 2. Check the spring upper pad and lower pad for aging or damage. ...

Rear Assist Arm Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S termi ...

Interior B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Categories


Copyright В© www.ksmanual.com 2014-2024