Kia Sorento: Tire Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Suspension System / Tires/Wheels / Tire Installation
| 1. |
Apply tire soap or lubrication to the top and bottom tire beads.
|
| 2. |
To fit the bottom bead, position the valve at the 5 o’clock position
relative to the head on the tire changing machine.
|
| 3. |
Place the tire on the rim so the bottom bead touches the edge
of the rim after the valve (6 o’clock). Rotate the rim clockwise, and
push down on the tire at the 3 o’clock position to fit bottom bead.
|
| 4. |
After bottom bead is on tire, rotate the rim until the valve is
at the 5 o’clock position relative to the head on the tire changing
machine. Push down on the tire at the 3 o’clock position and rotate
the rim clockwise to fit the top bead.
|
| 5. |
Inflate the tire until both beads seat.
|
Tire Removal
1.
Remove valve core and deflate the tire.
2.
Remove the side of the tire bead area from the wheel using tire
changing machine .
...
Wheel Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Water pump Inspection
1.
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
2.
Check the bearing for damage, abnorm ...
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft)
...
Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation
of the input shaft inside the transaxle and delivers the readings to the Transaxle
Control Module(TCM). The sensor pr ...
Copyright © www.ksmanual.com 2014-2024