Kia Sorento: Description
EPS (Electric power steering, Column assist type) system uses an electric
motor to assist the steering force and it is an engine operation independent
steering system.
EPS control module controls the motor operation according to information
received from the each sensor and CAN (Controller Area Network),
resulting in a more precise and timely control of steering assist than
conventional engine-driven hydraulic systems. Components (Steering Angle Sensor,
Torque Sensor, Fail-safe relay, etc.) of the EPS system are located inside the
steering column. EPS unit assembly, steering column, and EPS unit assembly must
not be disassembled for inspection. They must be replaced if necessary.
Note With Regard to diagnosis
| Trouble factor |
Check item |
Trouble symtom |
Explanation |
Note |
| Drop, impact, and overload |
Motor |
Abnormal noise |
- Visable or unvisable damage can occur.The steering wheel could
pull to one side by using the dropped parts.- Precise parts of motor/ECU
are sensitive to vibration and impact.- Overload can cause unexpected damage |
- Do not use the impacted EPS.- Do not overload each parts. |
| ECU |
Circuit damage- Wrong welding point- Broken PCB- Damaged precise
parts |
|||
| Torque sensor |
Insufficient steering effort |
Overload to INPUT shaft can cause malfunction of the torque
sensor |
- Do not impact the connecting parts (When inserting and torquing)-
Use the specified tool to remove the steering wheel. (Do not hammer on it)-
Do not use the impacted EPS |
|
| Shaft |
Insufficient steering effort (Uneven between LH and RH) |
|
Do not use the impacted EPS |
|
| Pull/Dent |
Harness |
- Malfunction-impossible power operation- Malfunction of EPS |
Disconnection between harness connecting portion and harness |
Do not overload the harness |
| Abnormal storage temperature |
Motor/ECU |
Abnormal steering effort by improper operation of the motor/ECU |
- Waterproof at the normal condition- Even a little moisture
can cause malfunction of the precise parts of the motor/ECU |
- Keep the normal temperature and proper moisture, while storaging-
Avoid drowning |
1. Do not impact the electronic parts, if they are dropped or impacted,
replace them with new ones.
2. Avoid heat and moisture to the electronic parts.
3. Do not contact the connect terminal to avoid deformation and static
electricity.
4. Do not impact the motor and torque sensor parts, if they are dropped
or impacted, replace them with new ones.
5. The connector should be disconnected or connected with IG OFF.
Components
1. Steering column shaft
2. ECU
3. Motor
4. Steering gear box
...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS)
Torque converter control solenoid valve (T/CON) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the torque converter.
...
Interior C
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Description
Evaporative Emission Control System prevents fuel vapor stored in fuel
tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel
tank, the vapor passes through vent hoses ...
Copyright В© www.ksmanual.com 2014-2025