Kia Sorento: Steering Column and Shaft Disassembly
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Steering System / Electric Power Steering / Steering Column and Shaft Disassembly
Universal joint assembly
| 1. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the steering column assembly.
|
| 2. |
Reassembly is the reverse of the disassembly.
|
Key lock assembly
| 1. |
Make a groove on the head of special bolts (A) by a punch.
|
| 2. |
Loosen the special bolt using a screw driver and then remove the
key lock assembly from the steering column assembly.
|
| 3. |
Reassembly is the reverse of the disassembly.
|
Steering Column and Shaft Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...
Steering Column and Shaft Inspection
1.
Check the steering column for damage and deformation.
2.
Check the joint bearing for damage and wear.
3.
Che ...
See also:
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor
and is installed on the surge tank. It senses absolute pressure of the surge
tank and transfers the analog signal propo ...
Seat Belt Pretensioner (BPT) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
Copyright В© www.ksmanual.com 2014-2024