1. |
Remove the rear wheel & tire.
|
2. |
Loosen the guide rod bolt (B) and pivot the caliper (A) up out
of the way.
|
3. |
Replace pad shim (D), pad retainers (C) and brake pads (B) in
the caliper carrier (A).
|
4. |
Compress the piston into the caliper body using the SST (09581-11000).
|
5. |
Place the caliper body (A) on the caliper carrier and tighten
the guide rod bolt (B).
|
6. |
Install the rear wheel & tire.
|
Canister Installation
1.
Install in the reverse order of removal.
...
Replacement
Problems And Replacement Parts:
Problem
Part set
Scan tool required?
All keys have been lost
Blank key (4)
YES
Antenna coil unit does n ...
Windshield Deicer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...