Kia Sorento: Parking Brake Pedal Assembly Removal
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
| 3. |
Remove the junction box.
(Refer to Body Electrical System - "Relay Box(Passenger Compartment"))
|
| 4. |
Disconnect the parking brake switch connector.
|
| 5. |
Remove the parking brake cable mounting nuts (A).
|
| 6. |
Remove the parking brake pedal mounting bolts (A) and nut (B).
|
| 7. |
Remove the parking brake cable the fixing clip (A, B), and then
remove the parking brake pedal.
|
Parking Brake Lever Assembly Adjustment
Parking Brake Lever Stroke Adjustment
1.
Remove the floor console.
(Refer to Body - "Floor console")
2.
Apply the brake p ...
Parking Brake Pedal Assembly Installation
1.
Install the holding clip (A, B) after fixing the parking brake
cable.
2.
Install the parking brake pedal, and then install the p ...
See also:
CVVT & Camshaft Installation
1.
Install the intakeCVVT assembly(A), exhaust CVVT assembly(B) and camshaft(C).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39 ...
Yaw-rate and G Sensor Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Timing Chain Cover Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright © www.ksmanual.com 2014-2025