Kia Sorento: Audio system
✽ NOTICE
If you install an after market HID head lamp, your vehicle’s audio and electronic
device may malfunction.
Antenna
Your vehicle uses a roof antenna to receive AM or/and FM broadcast signals.
This antenna is removable. To remove the roof antenna, turn it counterclockwise.
To install the roof antenna, turn it clockwise.
CAUTION
- Before entering a place with a low height clearance or a vehicle wash,
remove the antenna by rotating it counter-clockwise. If not, the antenna may
be damaged.
- When reinstalling your roof antenna, it is important that it is fully
tightened and adjusted to the upright position to ensure proper reception. But
it could be removed when parking the vehicle or when loading cargo on the roof
rack.
- When cargo is loaded on the roof rack, do not place the cargo near the
antenna pole to ensure proper reception.
Steering wheel audio control (if equipped)
The steering wheel may incorporate audio control buttons. These buttons are installed
to promote safe driving.
CAUTION
Do not operate audio remote control buttons simultaneously.
VOLUME (VOL + / - ) (1)
- Push the lever upward (+) to increase the volume.
- Push the lever downward (-) to decrease the volume.
SEEK/PRESET (
/ )
(2)
The SEEK/PRESET button has different functions based on the system mode. For
the following functions the button should be pressed for 0.8 seconds or more.
RADIO mode
It will function as the AUTO SEEK select button.
CD/USB/iPod® mode
It will function as the FF/REW button. If the SEEK/PRESET button is pressed for
less than 0.8 seconds, it will work as follows in each mode.
RADIO mode
It will function as the PRESET STATION buttons.
CD/USB/iPod® mode
It will function as TRACK UP/DOWN button.
MODE (3)
Press the button to change audio source.
- FM(1~2)➟AM➟SAT(1~3)➟CD➟ USB AUX(iPod®) FM...
MUTE (4)
- Press the button to mute the sound.
- Press the button to turn off the microphone during a telephone call.
Detailed information for audio control buttons are described in the following
pages in this section.
Aux, USB port (if equipped)
If your vehicle has an aux and/or USB(universal serial bus) port, you can use
an aux port to connect audio devices and an USB and also an iPod®.
✽ NOTICE
When using a portable audio device connected to the power outlet, noise may
occur during playback. If this happens, use the power source of the portable audio
device.
How vehicle audio works
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle.
This signal is then processed by the radio and sent to your vehicle speakers.
When a strong radio signal has reached your vehicle, the precise engineering
of your audio system ensures the best possible quality reproduction. However, in
some cases the signal coming to your vehicle may not be strong and clear.
This can be due to factors, such as the distance from the radio station, closeness
of other strong radio stations or the presence of buildings, bridges or other large
obstructions in the area.
AM broadcasts can be received at greater distances than FM broadcasts. This is
because AM radio waves are transmitted at low frequencies.
These long distance, low frequency radio waves can follow the curvature of the
earth rather than traveling straight. In addition, they curve around obstructions
resulting in better signal coverage.
FM broadcasts are transmitted at high frequencies and do not bend to follow the
earth's surface. Because of this, FM broadcasts generally begin to fade within short
distances from the station. short distances from the station. Also, FM signals are
easily affected by buildings, mountains, and obstructions. This can lead to undesirable
or unpleasant listening conditions which might lead you to believe a problem exists
with your radio. The following conditions are normal and do not indicate radio trouble:
- Fading - As your vehicle moves away from the radio station, the signal will
weaken and sound will begin to fade. When this occurs, we suggest that you select
another stronger station.
- Flutter/Static - Weak FM signals or large obstructions between the transmitter
and your radio can disturb the signal causing static or fluttering noises to
occur. Reducing the treble level may lessen this effect until the disturbance
clears.
- • Station Swapping - As an FM signal weakens, another more
powerful signal near the same frequency may begin to play. This is because your
radio is designed to lock onto the clearest signal. If this occurs, select another
station with a stronger signal.
- • Multi-Path Cancellation - Radio signals being received
from several directions can cause distortion or fluttering. This can be caused
by a direct and reflected signal from the same station, or by signals from two
stations with close frequencies. If this occurs, select another station until
the condition has passed.
Using a cellular phone or a twoway radio
When a cellular phone is used inside the vehicle, noise may be
produced from the audio system. This does not mean that something is wrong with
the audio equipment. In such a case, try to operate mobile devices as far from the
audio equipment as possible.
CAUTION
When using a communication system such as a cellular phone
or a radio set inside the vehicle, a separate external antenna must be fitted. When
a cellular phone or a radio set is used with an internal antenna alone, it may interfere
with the vehicle's electrical system and adversely affect safe operation of the
vehicle.
WARNING
Do not use a cellular phone while driving. Stop at a safe
location to use a cellular phone.
Caring for disc
- • If the temperature inside the car is too high, open the
car windows to ventilate before using the system.
- • It is illegal to copy and use MP3/WMA files without permission.
Use CDs that are created only by lawful means.
- • Do not apply volatile agents, such as benzene and thinner,
normal cleaners and magnetic sprays made for analogue disc onto CDs.
- • To prevent the disc surface from getting damaged, hold
CDs by the edges or the center hole only.
- • Clean the disc surface with a piece of soft cloth before
playback (wipe it from the center to the outside edge).
- • Do not damage the disc surface or attach pieces of sticky
tape or paper.
- • Make certain only CDs are inserted into the CD player
(Do not insert more than one CD at a time).
- • Keep CDs in their cases after use to protect them from
scratches or dirt.
- • Depending on the type of CDR/ CD-RW CDs, certain CDs may
not operate normally according to the manufacturing companies. In such circumstances,
continued use may cause malfunctions to your audio system.
✽ NOTICE - Playing an Incompatible Copy Protected Audio CD
Some copy protected CDs, which do not comply with international audio CD standards
(Red Book), may not play on your car audio. Please note that inabilities to properly
play a copy protected CD may indicate that the CD is defective, not the CD player.
NOTE:
Order of playing files (folders) :
1. Song playing order :
to sequentially.
2. Folder playing order :
WARNING
- Do not stare at the screen while driving. Staring at the screen for prolonged
periods of time could lead to traffic accidents.
- Do not disassemble, assemble, or modify the audio system. Such acts could
result in accidents, fire, or electric shock.
- Using the phone while driving may lead to a lack of attention of traffic
conditions and increase the likelihood of accidents. Use the phone feature after
parking the vehicle.
- Heed caution not to spill water or introduce foreign objects into the
device. Such acts could lead to smoke, fire, or product malfunction.
- Please refrain from use if the screen is blank or no sound can be heard
as these signs may indicate product malfunction. Continued use
in such conditions could lead to accidents(fires, electric shock) or
product malfunctions.
- Do not touch the antenna during thunder or lightening as such acts may
lead to lightning induced electric shock.
- Do not stop or park in parking- restricted areas to operate the product.
Such acts could lead to traffic accidents.
- Use the system with the vehicle ignition turned on. Prolonged use with
the ignition turned off could result in battery discharge.
CAUTION
- Operating the device while driving could lead to accidents due to a lack
of attention to external surroundings. First park the vehicle before operating
the device.
- Adjust the volume to levels that allow the driver to hear sounds from
outside of the vehicle. Driving in a state where external sounds cannot be heard
may lead to accidents.
- Pay attention to the volume setting when turning the device on. A sudden
output of extreme volume upon turning the device on could lead to hearing impairment.
(Adjust the volume to a suitable levels before turning off the device.)
- If you want to change the position of device installation, please inquire
with your place of purchase or service maintenance center. Technical expertise
is required to install or disassemble the device.
- Turn on the car ignition before using this device. Do not operate the
audio system for long periods of time with the ignition turned off as such operations
may lead to battery discharge.
- Do not subject the device to severe shock or impact. Direct pressure
onto the front side of the monitor may cause damage to the LCD or touch screen.
- When cleaning the device, make sure to turn off the device and use a
dry and smooth cloth. Never use tough materials, chemical cloths, or solvents
(alcohol, benzene, thinners, etc.) as such materials may damage the device panel
or cause color/quality deterioration
- Do not place beverages close to the audio system. Spilling beverages
may lead to system malfunction.
- In case of product malfunction, please contact your place of purchase
or After Service center.
- Placing the audio system within an electromagnetic environment may result
in noise interference.
- Prevent caustic solutions such as perfume and cosmetic oil from contacting
the dashboard because they may cause damage or discoloration.
If the vehicle has a roof rack, you can load cargo on top of your vehicle.
✽ NOTICE
If the vehicle is equipped with a sunroof, be sure not to position cargo onto
the roof rack in such a wa ...
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
See also:
Installation
1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
...
Rear combination lamp Installation
1.
Install the tailgate combination lamp assembly after replacing
the bulb.
2.
Install the lamp cover to the tailgate after connecting the ...
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...