Kia Sorento: Ambient Temperature Sensor Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Ambient Temperature Sensor Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Remove the front bumper.
(Refer to Body - "Front Bumper")
|
| 3. |
Disconnect ambient temperature sensor.
|
| 4. |
Check the resistance of the ambient temperature sensor between
terminals 1 and 2 whether it changes by changing the ambient temperature.
Specification
|
| 5. |
If the measured resistance is not within specification, substitute
with a known-good ambient temperature sensor and check for proper operation.
|
| 6. |
Replace the ambient temperature sensor if it is proved that there
is a problem with the sensor.
|
Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser
and detects ambient air temperature. It is a negative type thermistor; resistance
will increase with lower temperature, ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper")
...
See also:
Blower Motor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Oil Seal Replacement
[Right side]
1.
Remove the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
2.
Re ...
Copyright © www.ksmanual.com 2014-2024