Kia Sorento: Blade inspection - Wiper blades - Maintenance - Kia Sorento XM Owners ManualKia Sorento: Blade inspection

Second Generation XM (2011-2024) / Kia Sorento XM Owners Manual / Maintenance / Wiper blades / Blade inspection

✽ NOTICE


✽ NOTICE

Commercial hot waxes applied by automatic vehicle washes have been known to make the windshield difficult to clean.

Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers.

Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial vehicle washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.

CAUTION

To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.

Blade replacement

When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.

CAUTION

To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.

CAUTION

The use of a non-specified wiper blade could result in wiper malfunction and failure.

Front windshield wiper blade

Type A


Type A

1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.

CAUTION

Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.

2. Compress the clip and slide the blade assembly downward.


2. Compress the clip and slide the blade assembly downward.

3. Lift it off the arm.

4. Install the blade assembly in the reverse order of removal.

Type B


Type B

1. Raise the wiper arm.

CAUTION

Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.

2. Lift up the wiper blade clip. Then pull down the blade assembly and remove


2. Lift up the wiper blade clip. Then pull down the blade assembly and remove it.

3. Install the new blade assembly in the reverse order of removal.


3. Install the new blade assembly in the reverse order of removal.

Rear window wiper blade

1. Raise the wiper arm and pull out the wiper blade assembly.


1. Raise the wiper arm and pull out the wiper blade assembly.

2. Install the new blade assembly by inserting the center part into the slot


2. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place.

3. Make sure the blade assembly is installed firmly by trying to pull it slightly.

To prevent damage to the wiper arms or other components, have an authorized Kia dealer replace the wiper blade.

Wiper blades
...

Battery
...

See also:

Head Lamps Replacement
Bulb (HID) 1. Turn the head lamp switch off. 2. Disconnect the power connector from the lamp. 3. Remove the ...

Rear Air Conditioner Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recover/recycling/charging station. 3. ...

Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostati ...

Copyright В© www.ksmanual.com 2014-2024