Kia Sorento: Blind Spot Detection Switch Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Switch Inspection
| 1. |
Disconnect the BSD switch connector.
|
| 2. |
Operate the BSD switch, then check for continuity between terminals
of BSD switch connector.
|
Blind Spot Detection Switch Installation
1.
Install the crash pad side switch assembly after connecting the
connector.
2.
Install the crash pad lower panel.
...
See also:
Accelerator Pedal Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Side Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
3. TCM Terminal input/ output signal
Connector [A]
Pin No.
Signal
Condition
Type
Level
29
Sports mode up switch
Up ON
Input
0V/Battery voltage level
...
Copyright В© www.ksmanual.com 2014-2024