Kia Sorento: Brake Line Inspection - Brake System - Brake System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Brake Line Inspection

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Brake System / Brake System / Brake Line Inspection

1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3.
Check the brake tube flare nuts for damage and fluid leakage.
4.
Check brake hose mounting bracket for crack or deformation.
Brake Line Removal
1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder rese ...

Brake Line Installation
1. Installation is the reverse of removal.    Use a new washer (A) whenever ...

See also:

Rear Coil Spring Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Copyright В© www.ksmanual.com 2014-2025