Kia Sorento: Checking the brake/clutch fluid level - Brake fluid - Maintenance - Kia Sorento XM Owners ManualKia Sorento: Checking the brake/clutch fluid level

Second Generation XM (2011-2024) / Kia Sorento XM Owners Manual / Maintenance / Brake fluid / Checking the brake/clutch fluid level

Check the fluid level in the reservoir periodically. The fluid level should be


Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.

Before removing the reservoir cap and adding brake/clutch* fluid, clean the area around the reservoir cap thoroughly to prevent brake/clutch fluid contamination.

If the level is low, add fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings and/or clutch disc (if equipped). If the fluid level is excessively low, have the brake/clutch* system checked by an authorized KIA dealer.

WARNING - Loss of brake/clutch  fluid

In the event the brake/clutch system requires frequent additions of fluid, the vehicle should be inspected by an authorized Kia dealer.

WARNING - Brake/ clutch  fluid

When changing and adding brake/clutch  fluid, handle it carefully. Do not let it come in contact with your eyes. If brake/ clutch  fluid should come in contact with your eyes, immediately flush them with a large quantity of fresh tap water. Have your eyes examined by a doctor as soon as possible.

CAUTION

Do not allow brake/clutch  fluid to contact the vehicle's body paint, as paint damage will result. Brake/clutch  fluid, which has been exposed to open air for an extended time should never be used as its quality cannot be guaranteed. It should be disposed of properly. Don't put in the wrong kind of fluid. A few drops of mineral-based oil, such as engine oil, in your brake/ clutch   system can damage brake/clutch  system parts.

Brake fluid
...

Washer fluid
...

See also:

Idler Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightenin ...

TPMS Sensor Removal
Tire Removal 1. Deflate tire & remove balance weights.    ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Copyright В© www.ksmanual.com 2014-2024