1. |
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent, gently
bend them using a screwdriver or pliers.
|
2. |
Check the condenser connections for leakage, and repair or replace
it, if required.
|
Fuel requirements
Your new vehicle is designed to use only unleaded fuel having a pump octane number
((R+M)/2) of 87 (Research Octane Number 91) or higher.
Your new vehicle is designed to obtain maximum performance w ...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross Veh ...
In-car Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...