Kia Sorento: Front Washer Motor Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor Removal
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
| 3. |
Remove the washer hose and disconnect the washer motor connector
(A) and washer fluid level sensor connector (B).
|
| 4. |
Remove the washer motor (A).
|
| 5. |
Remove the washer reservoir after removing bolts (A).
|
Front Washer Motor Inspection
Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
&nb ...
Front Washer Motor Installation
1.
Reassemble the washer reservoir.
Before installing the pump motor, che ...
See also:
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Seat Heater Removal
1.
Remove the driver / assist seat back heater (A) and cushion heater
(B).
(Refer to Body - "Front seat")
2.
...
Yaw-rate and G Sensor Description
The yaw rate and G sensor is included inside the air bag control module
(SRSCM).
When the vehicle is turning with respect to a vertical axis the yaw rate
sensor detects the yaw rate elec ...
Copyright В© www.ksmanual.com 2014-2024