Kia Sorento: Front Fog Lamps Removal - Lighting System - Body Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Front Fog Lamps Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Lighting System / Front Fog Lamps Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the front tire wheel guard.
(Refer to Body - "Front bumper")
3.
Turn the bulb socket counterclockwise and then remove the fog lamp bulb.

4.
If it is necessary to replace the lamp assembly, remove the fog lamp (A) after loosening the screws.

Front Fog Lamps Inspection
1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunctio ...

Front Fog Lamps Installation
1. Install the front fog lamp bulb. 2. Connect the fog lamp connector. 3. Install the front tire wheel guard. ...

See also:

Description
Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the ...

SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

4WD ECU Removal
1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. (Refer to 4WD Control System - "Repair procedures") ...

Copyright В© www.ksmanual.com 2014-2024