Kia Sorento: Inspection
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Circuit Diagram
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
See also:
Yaw-rate and G Sensor Installation
1.
Remove the ignition key from the vehicle.
2.
Install inthe reverse order of removal.
3.
After installing the ...
Delivery Pipe Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
Oil Seal Replacement
[Right side]
1.
Remove the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
2.
Re ...
Copyright В© www.ksmanual.com 2014-2025