Kia Sorento: Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the HO2S connector.
|
| 3. |
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
|
| 4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and then remove the sensor ...
See also:
Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on driver and pass ...
Component Location
1. Overdrive Clutch (OD/C)
2. One way Clutch (OWC)
3. Low & Reverse Brake (LR/B)
4. Underdrive Brake (UD/B)
5. 26 Brake(26/B)
6. 35R Clutch (35R/C)
7. Damper Clu ...
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons
or turning knob(s) other than the AUTO button. In this case, the system works sequentially
according to the order of but ...
Copyright © www.ksmanual.com 2014-2025