Kia Sorento: Installation
| 1. |
Install the multifunction switch.
|
| 2. |
Install the clock spring and steering wheel.
|
| 3. |
Install the steering column upper and lower shrouds.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 screws.
...
Inspection
Lighting Switch Inspection
1.
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is no ...
See also:
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Alternator Disassembly
1.
Remove the alternator cover (A) using a screw driver after loosening
the nuts (B).
2.
Remove the slip ring guide (A) and then lo ...
Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge control solen ...
Copyright В© www.ksmanual.com 2014-2025