Kia Sorento: Intake Actuator Description - Blower - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Intake Actuator Description

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Intake Actuator Description

The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Climate Control Air Filter Replacement
1. Disconnect the stopper (B) from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). ...

Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...

See also:

Troubleshooting
Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) blown Check for short and replace fuse Speedometer faulty ...

Lane Departure Warning System (LDWS) Unit Installation
1. Install the LDWS unit. 2. Install the LDWS unit cover. 3. Check LDWS system operation. ...

Inspection
[Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied ...

Copyright В© www.ksmanual.com 2014-2024